ХАРАКТЕРИСТИКА ТУРБУЛЕНТНОГО ТЕЧЕНИЯ С ПОМОЩЬЮ ЧИСЛЕННОГО МОДЕЛИРОВАНИЯ
Keywords:
turbulence, swirling flow, axial velocity, tangential velocity, cutoff diameter, pressure dropAbstract
The article suggests using an equation for turbulent viscosity and analytical relationships from reliable sources to determine the size of turbulence. The boundary layer equation was utilized for mathematical modeling; it was expressed in stationary form in physical coordinates. Known from sources numerical methods are applied to solve these equations.
References
Муродов О.Ж, Адилова А.Ш , “Kanaldagi changning xarakat dinamikasi uchun Nav'e-Stoks tenglamasini yechish bo'yicha kompyuter dasturi” OʻzRAVHIMA № DGU 12975. 13.11.2021;
Hinze, J., Turbulence. McGraw-Hill, USA. (1975).
Karimipanah, T.,Turbulent jets in confined spaces. Ph.D. thesis, Royal Institute of Technology, Sweden (1996)
Griffiths W.D, Boysan F., Computational fluid dynamics (CFD) and empirical modelling of the performance of a number of cyclone samplers, Journal of Aerosol Science 27 (2) (1996) pp.281–304.
Hoekstra A.J, Gas Flow Field and Collection Efficiency of Cyclone Separators, Ph.D. thesis, Technical University Delft,(2000).
Secchiaroli A, Ricci R, Montelpare S, Alessandro V.D., Numerical simulation of turbulent flow in a Ranque–Hilsch vortex tube, International Journal of Heat and Mass Transfer 52 (23-24) (2009) pp.5496–5511.
Chuah T, Gimbun J, Choong T.S., A CFD study of the effect of cone dimensions on sampling aero cyclones performance and hydrodynamics, Powder Technology 162 (2006) pp.126–132.
G. Wan G, Sun G, X. Xue, Shi M., Solids concentration simulation of different size particles in a cyclone separator, Powder Technology 183 (2008) pp. 94–104.
Kaya F, Karagoz I., Performance analysis of numerical schemes in highly swirling turbulent flows in cyclones, Current Science 94 (10)(2008) pp.1273–1278.
Bernardo S, Mori M, Peres A, DioNiSio R., 3-D computational fluid dynamics for gas and gas-particle flows in a cyclone with different inlet section angles, Powder Technology 162 (3) (2006) pp.190–200.
